7.5 Setting the TIME DELAY
function
1. Set a heating function and
temperature.
2. Press
again and again until
starts to flash.
3. Press or to set the minutes
for DURATION.
4. Press .
5. Press
or to set the hours for
DURATION.
6. Press .
The display shows flashing .
7. Press or to set the END time
and press
. First you set the
minutes and then the hours.
The oven turns on automatically later on,
works for the set DURATION time and
stops at the set END time. When the set
time ends, the signal sounds for 2
minutes. The display shows flashing
and the time setting . The oven turns off
automatically.
8. Press a sensor field to stop the
signal.
9. Turn off the oven.
When the Time delay
function is turned on, the
display shows a symbol of
the heating function,
with a dot and . The dot
shows which clock function
is on in the Clock / residual
heat display.
7.6 Setting: Minute Minder
1. Press .
The display shows flashing and "00".
2. Press to switch between options.
First you set the seconds, then the
minutes and the hours.
3. Press
or to set the MINUTE
MINDER and to confirm.
4. Press or the MINUTE MINDER
starts automatically after 5 seconds.
When the set time ends, the signal
sounds for 2 minutes and the display
shows flashing 00:00 and .
5. Press a sensor field to stop the
signal.
7.7 COUNT UP TIMER
1. To reset the Count Up Timer press:
and at the same time .
2. When the display shows "00:00" the
Count Up Timer starts to count up
again.
8. AUTOMATIC PROGRAMMES
WARNING!
Refer to Safety chapters.
There are 9 automatic programmes. Use
an automatic programme or recipe when
you do not have the knowledge or
experience on how to prepare a dish.
The display shows the default cooking
times for all automatic programmes.
8.1 Automatic programmes
Programme number Programme name
1 VEGETABLES, TRADITIONAL
ENGLISH 15
To Next Page
Loading...
