SHELF SUPPORTS
Removing the shelf supports
You can remove the shelf supports to clean
the side walls.
1.
Pull the front of the shelf support away
from the side wall.
1
2
2.
Pull the rear end of the shelf support
away from the side wall and remove it.
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
Valid for telescopic runners:
The retaining pins on the telescopic
runners must point to the front.
LAMP
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass cover
can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the in-
terior of the appliance. It prevents
damage to the lamp glass cover
and the cavity.
Always use the same lamp type.
Replacing the lamp at the cavity
ceiling:
1.
Turn the lamp glass cover counter-
clockwise to remove it.
2.
Clean the glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Install the glass cover.
30
www.electrolux.com
To Next Page
Loading...
