Electrolux EOD6P66X - 12.2 How to clean: Cavity embossment; 12.3 How to remove: Shelf supports; 12.4 How to use: Pyrolytic Cleaning

12.2 How to clean: Cavity embossment
Clean the cavity embossment to remove limestone residue after cooking with steam.
Step 1 Step 2 Step 3
Pour: 250 ml of white vinegar
into the cavity embossment.
Use maximum 6% vinegar
without any additives.
Let the vinegar dissolve the
limestone residue at the ambi‐
ent temperature for 30 mi‐
nutes.
Clean the cavity with warm
water and a soft cloth.
For the function: SteamBake clean the oven for every 5 - 10 cooking cycles.
12.3 How to remove: Shelf supports
Remove the shelf supports to clean the oven.
Step 1 Turn off the oven and wait until
it is cold.
Step 2 Pull the front of the shelf sup‐
port away from the side wall.
Step 3 Pull the rear end of the shelf
support away from the side wall
and remove it.
2
1
Step 4 Install the shelf supports in the
opposite sequence.
12.4 How to use: Pyrolytic Cleaning
Clean the oven with Pyrolytic Cleaning.
WARNING!
There is a risk of burns.
CAUTION!
If there are other appliances installed in the same cabinet, do not use them at the
same time as this function. It can cause damage to the oven.
29/40
CARE AND CLEANING