Q&CI - Technical Support 12 599 83 20-19 Rev. 02
7 WI-FI CONNECTIVITY SETUP
To setup, install the app, connect the appliance to the Wi-Fi network and then link it to the mobile device.
Frequency 2.412 - 2.472 GHz
Protocol IEEE 802.11b/g/n
Pre-requisites:
• Wireless 2.4GHz network with internet connection enabled.
• Mobile device connected to the wireless network.
7.1 Install the application “My Electrolux Kitchen”
1. Go to the app store on the mobile device
2. Download and install the app “My Electrolux Kitchen”
3. Start the application. Select country and language and login or create a new account.
7.2 Configure the wireless connection
Stand near the appliance with the mobile device (Android or iOS). Make sure that the mobile device is connected to
the wireless network that the appliance will be connected to.
In the app:
1. Tap the appliances icon in the menu and then the Add Appliance icon.
2. Choose “Fridge” in the list of appliances and tap “NEXT”.
3. Follow the app’s guidance.
On your appliance:
1. Press and hold the Wi-Fi icon for 3 seconds until you hear a beep to start the Wi-Fi system.
2. After about 45 seconds the UI displays AP.
In the app:
1. Continue to follow the app guidance.
• Android devices, select the appliance’s Wi-Fi network in the drop down list.
• iOS devices go to “SETTINGS” and select the appliance’s Wi-Fi network, (it is the one that begins
with AJ-)
2. When the appliance has connected, the Wi-Fi icon stops flashing and stays solid.
7.3 Disabling / resetting the appliance wireless connection
1. Temporarily disable: Press and hold the Wi-Fi icon for 3 seconds. The Wi-Fi icon switches off and a
beep sounds.
2. Re-establish: Press and hold the Wi-Fi icon for 3 seconds.
3. Reset the Wi-Fi configuration: Press and hold the Wi-Fi and the Reset Water Filter icon together for 10
seconds. To then re-establish the connection, repeat the steps in section Configure the wireless
connection.
To Next Page
Loading...
