Electrolux ESS42200SW User Manual

8.1 The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt
container (only for the first time).
3. Fill the salt container with 1 kg of salt
(until it is full).
4. Carefully shake the funnel by its
handle to get the last granules inside.
5. Remove the salt around the opening
of the salt container.
6. Turn the cap of the salt container
clockwise to close the salt container.
CAUTION!
Water and salt can come out
of the salt container when
you fill it. After you fill the
salt container, immediately
start a programme to
prevent corrosion.
8.2 How to fill the rinse aid
dispenser
B
C
A
CAUTION!
The compartment (C) is for
rinse aid only. Do not fill it
with detergent.
CAUTION!
Only use rinse aid designed
specifically for dishwashers.
1. Press the release element (A) to
open the lid (B).
2. Pour the rinse aid in the dispenser
(C) until the liquid reaches the
marking "FILL".
3. Remove the spilled rinse aid with an
absorbent cloth to prevent excessive
foam formation.
4. Close the lid. Make sure that the lid
locks into position.
9. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
Make sure that the appliance is in
programme selection mode.
• If the salt indicator is on, fill the
salt container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start a programme suitable
for the type of load and the degree of
soil.
www.electrolux.com14

Electrolux ESS42200SW Specifications

General

Door color	White
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Outlet hose length	1.5 m
Appliance placement	Freestanding
Cycle time	160 min
Noise level	49 dB
Drying system	AirDry
Delay start (max)	24 h
Number of place settings	9 place settings
Number of washing programs	8
Number of temperature settings	4
Current	10 A
Connected load	1950 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Water consumption per cycle	9.9 L
Energy consumption per cycle	0.689 kWh

Weight and Dimensions

Depth	615 mm
Width	446 mm
Height	850 mm
Weight	36900 g
Installation compartment depth	570 mm
Installation compartment width	450 mm
Installation compartment height (min)	820 mm