Electrolux ESS42200SW User Manual

Problem and alarm code Possible cause and solution
The anti-flood device is on.
The display shows i30.
• Close the water tap.
• Make sure that the appliance is correctly installed.
• Make sure the baskets are loaded as instructed in
the user manual.
Malfunction of the water
level detection sensor.
The display shows i41 -
i44.
• Make sure that the filters are clean.
• Switch the appliance off and on.
Malfunction of the wash
pump or the drain pump.
The display shows i51 -
i59 or i5A - i5F.
• Switch the appliance off and on.
The temperature of the wa‐
ter inside the appliance is
too high or malfunction of
the temperature sensor oc‐
curred.
The display shows i61 or
i69.
• Make sure that the temperature of the inlet water
does not exceed 60°C.
• Switch the appliance off and on.
Technical malfunction of
the appliance.
The display shows iC0 or
iC3.
• Switch the appliance off and on.
The level of water inside
the appliance is too high.
The display shows iF1.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation in‐
structions.
The appliance stops and
starts more times during
operation.
• It is normal. It provides optimal cleaning results and
energy savings.
The programme lasts too
long.
• If the delayed start is set, cancel the delay setting or
wait for the end of the countdown.
The displayed programme
duration is different than
the duration in the con‐
sumption values table.
• The pressure and the temperature of the water, the
variations of the mains supply, the options, the quan‐
tity of dishes and the degree of soil can change the
programme duration.
The remaining time in the
display increases and
skips nearly to the end of
programme time.
• This is not a defect. The appliance is working cor‐
rectly.
Small leak from the appli‐
ance door.
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
www.electrolux.com22

Electrolux ESS42200SW Specifications

General

Door color	White
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Outlet hose length	1.5 m
Appliance placement	Freestanding
Cycle time	160 min
Noise level	49 dB
Drying system	AirDry
Delay start (max)	24 h
Number of place settings	9 place settings
Number of washing programs	8
Number of temperature settings	4
Current	10 A
Connected load	1950 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Water consumption per cycle	9.9 L
Energy consumption per cycle	0.689 kWh

Weight and Dimensions

Depth	615 mm
Width	446 mm
Height	850 mm
Weight	36900 g
Installation compartment depth	570 mm
Installation compartment width	450 mm
Installation compartment height (min)	820 mm