Electrolux ESS42200SW User Manual

Problem Possible cause and solution
Poor drying results. • Tableware was left for too long inside the closed
appliance. Activate the function AirDry to set the
automatic opening of the door and to improve the
drying performance.
• There is no rinse aid or the dosage of rinse aid is
not sufficient. Fill the rinse aid dispenser or set the
dosage of rinse aid to a higher level.
• The quality of the rinse aid can be the cause.
• Always use rinse aid, even with multi-tablets.
• Plastic items may need to be towel dried.
• The programme does not have the drying phase.
Refer to "Programmes overview".
There are whitish streaks or
bluish layers on glasses and
dishes.
• The released quantity of rinse aid is too high. Ad‐
just the rinse aid dosage to a lower level.
• The quantity of detergent is too high.
There are stains and dry wa‐
ter drops on glasses and
dishes.
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid dosage to a higher level.
• The quality of the rinse aid can be the cause.
The interior of the appliance
is wet.
• This is not a defect of the appliance. Humidity con‐
densates on the appliance walls.
Unusual foam during wash‐
ing.
• Use the detergent designed specifically for dish‐
washers.
• Use a detergent from a different manufacturer.
• Do not pre-rinse dishes under running water.
Traces of rust on cutlery. • There is too much salt in the water used for wash‐
ing. Refer to "The water softener".
• Silver and stainless steel cutlery were placed to‐
gether. Do not place silver and stainless steel items
close together.
There are residues of deter‐
gent in the dispenser at the
end of the programme.
• The detergent tablet was stuck in the dispenser
and was not washed away by water.
• Water cannot wash away the detergent from the
dispenser. Make sure that the spray arms are not
blocked or clogged.
• Make sure that items in the baskets do not impede
the lid of the detergent dispenser from opening.
Odours inside the appliance. • Refer to "Internal cleaning".
• Start the programme with a descaler or a clean‐
ing product designed for dishwashers.
www.electrolux.com24

Electrolux ESS42200SW Specifications

General

Door color	White
Control type	Buttons
Product size	Slimline (45 cm)
Built-in display	Yes
Custom panel-ready	-
Outlet hose length	1.5 m
Appliance placement	Freestanding
Cycle time	160 min
Noise level	49 dB
Drying system	AirDry
Delay start (max)	24 h
Number of place settings	9 place settings
Number of washing programs	8
Number of temperature settings	4
Current	10 A
Connected load	1950 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Water consumption per cycle	9.9 L
Energy consumption per cycle	0.689 kWh

Weight and Dimensions

Depth	615 mm
Width	446 mm
Height	850 mm
Weight	36900 g
Installation compartment depth	570 mm
Installation compartment width	450 mm
Installation compartment height (min)	820 mm