Electrolux TD50 - Description; General

7
Description
Description
Generel
From factory, the dryer has been set to specific values for:
Time, temperature, cooling, reversing, etc.
The above parameters are changeable by reprogramming the Selecta
Control PCB.
Selecta Control PCB
The PCB Module is located under the top cover on the front of the machi-
ne, see the service manual for the specific dryer.
NOTE!
OnWD4130andWD4240itislocatedontherearelectricalmodule.
In order to reprogramme the dryer it is necessary to switch the print board
into programming mode.
Glossary
Auto Stop The tumble dryer stops automatically when the clothes are dry.
AHL Apartment House Laundry - Communal laundries /
Housing block laundries.
GN Natural gas
LPG Bottle gas
OPL On Premises Laundry - Institutional laundries.
PCB Printed Circuit Board.
RMC Residual Moisture Control - The tumble dryer has residual
moisture control.