Electrolux Unic Tango Ace - Turntable Service Procedures

25
Tango 0060 5-2021
1. Remove the Brewing Piston
2. Remove the Turntable
3. Clean the Co󰀨ee Dosing & Turntable area
4. Install new Seals and Friction Pads under the Turntable
5. Repack the Turntable Bearing Grease
6. Adjust the tension on Turntable Bearing (turntable speed)
FR-1551
Turntable PM kit
Tango UNO/SOLO - ACE/ST
Tools needed:
Flat Blade Screwdriver
7 mm wrench
10 mm wrench
22 mm wrench
6 mm Allen wrench
2.5 mm Allen wrench
ACE / ST
UNO / SOLO
The Turntable speed (TT) should be
between 140ms -180ms
Tango Turntable Service
Every 2 years
(Or if leaking from underside of Turntable)
(Adjust Turntable Bearing Tension every 6 months, see next section)
FR-1551
Turntable PM kit