© 2018 Electromedical Technologies, Inc. Phoenix, AZ USA. Any use of editorial, pictorial or layout composition of this publication without express written consent from Electromedical Technologies,
Inc. is strictly prohibited. This publication was written, illustrated and prepared for print by Electromedical Technologies, Inc
57
Microcurrent range is from 10 µA (microamperes) to 600 µA and it is controlled by buttons:
Starting level is 10 µA (microamperes) and is increased in the following increments by pressing “+” button:
10 – 15 – 25 – 50 – 75 – 100 – 125 – 150 – 175 – 200 – 225 – 250 – 275 – 300 – 325 – 350 – 375 – 400 – 425
– 450 – 475 – 500 – 525 – 550 – 575 – 600
To reduce the microcurrent level, decrease the increments stated above by pressing “-“ button.
By pressing “+” or “-“ buttons, microcurrent level will go up or down on both sides
To control microcurrent level independently on side A and B, while program is running,
press and HOLD button for 2 seconds. Short “beep” will sound and the message
“Microcurrent level” on the A side of the screen will be highlighted. (see example below)
WellnessPro PLUS
Side B
Code: 102
Frequency: 10,000.00 Hz
Time: 3:00 min.
Total time: :00 min.
Wave type: 1
Lead intensity level: 0%
48
Microcurrent level: 10 uA
Side A
Code: 102
Frequency: 10,000.00 Hz
Time: 3:00 min.
Total time: 48:00 min.
Wave type: 1
Lead intensity level: 0%
10 uAMicrocurrent level:
At this point, pressing “+” or “-“ button will only affect microcurrent level on side A.
To switch, highlight bar on side B then press button again and adjust the
microcurrent level on side B by pressing “+” or “-“ buttons. (see the image below)
WellnessPro PLUS
Side A
Code: 102
Frequency: 10,000.00 Hz
Time: 3:00 min.
Total time: 48:00 min.
Wave type: 1
Lead intensity level: 0%
Microcurrent level: 175 uA
Side B
Code: 102
Frequency: 10,000.00 Hz
Time: 3:00 min.
Total time: :00 min.
Wave type: 1
Lead intensity level: 0%
48
50 uAMicrocurrent level:
To Next Page
Loading...
