Lesson 31 Stepper Motor
Overview
In this lesson, you will learn a fun and easy way to drive a stepper motor.
The stepper we are using comes with its own driver board making it easy to connect
to our MEGA2560.
Component Required:
(1) x Elegoo Mega2560 R3
(1) x 830 tie-points breadboard
(1) x ULN2003 stepper motor driver module
(1) x Stepper motor
(1) x 9V1A Adapter
(1) x Power supply module
(6) x F-M wires (Female to Male DuPont wires)
(1) x M-M wire (Male to Male jumper wire)
Component Introduction
To Next Page
Loading...