Code
After wiring, please open the program in the code folder- Lesson 9 Servo and click
UPLOAD to upload the program. See Lesson 2 for details about program uploading if
there are any errors.
Before you can run this, make sure that you have installed the < Servo> library or
re-install it, if necessary. Otherwise, your code won't work.
For details about loading the library file, see Lesson 1.
Example picture
In the picture, the brown wire of servo is adapted via the black M-M wires, the red
one is adapted via the red M-M wires, and the orange one is adapted via the yellow
M-M wires.
To Next Page
Loading...