18
fig.c1
fig.c2
fig.c3
Safety
C) Circulation (fig. c1):
• check the pulse (fig. c1)
• if absent, start cardiac massage (fig. c2)
• compress the chest every 1.5 - 2 seconds
• if a rescuer is present, perform 15 compressions in approximately 80 seconds, + 2
quick blows
• if there are two rescuers, perform 5 compressions in approximately 60 seconds, + 1
quick blow (fig. c3)
WARNING :
Do not interrupt the rhythm of compressions when the second person is performing
artificial respiration.
3.2.2.2 If the victim is responsive
• cover the victim with a blanket
• keep them as calm as possible
• loosen their clothing and place them in a reclining position
WARNING :
CALL FOR MEDICAL ASSISTANCE AS SOON AS POSSIBLE IN ALL CASES
3.3 Workplace characteristics
3.3.1 Room characteristics
In order to work freely on the equipment and to be able to perform the relative instal-
lation or maintenance operations, it is necessary to keep a minimum distance from the
walls on all sides of the machine.
The room must be equipped with an appropriate system of clean and dust-filtered air
ventilation with a flow rate suitable for the characteristics of the equipment operating
in the room itself.
Outgoing exhausted air must be conveyed directly outside. If the size or the length of
the duct is such that a significant loss in the air flow can be anticipated, it is necessary
to add an extraction device. Anti-intrusion devices must be provided at the conveyor
outlet (for insects or other animals) and precautions must be taken to prevent the en-
trance of liquids or other materials.
The equipment can operate properly if the temperature ranges from
-5°C to +45°C, with 95% RH non-condensing at +40°C.
3.3.2 Electrical system characteristics
The electrical system must comply with all applicable laws. The power supply network
must allow the supply of the appropriate power according to the laws in force in the
Country of installation on the quality of the electrical energy supply service.
It is highly recommended to use a transformer/network separator and a reduction net-
work for discharging high voltage.
Provide a protected under load disconnector (circuit breaker or fuses) with appropria-
te disconnection power and capacity according to the absorption characteristics of the
To Next Page
Loading...
Need help?
General
