What to do if Elenos ETG300 does not reach required power level?
If the Elenos Transmitter unit does not reach the required power level, first ensure that the unit is not in Stand-By mode. Access the RF menu and enable “RF On”. Also, check the connection of the antenna or amplifier, ensuring its integrity.
How to troubleshoot if Elenos ETG300 Transmitter will not power up?
If the Elenos Transmitter unit will not power up, connect or replace the power cable. If the issue persists, replace the power supply fuses located on the rear panel. If the “MAIN” front panel LED is not lit, it indicates an auxiliary power supply fault.
What to do if there is absence of modulation on the output and on the display of Elenos Transmitter?
If there is an absence of modulation on the output and on the display of your Elenos Transmitter, first connect or replace the audio cable. Additionally, verify that the modulation is enabled from the audio menu.
How to troubleshoot if modulation does not reach the required value on Elenos Transmitter?
If the modulation does not reach the required value on your Elenos Transmitter, increase the audio input level. Also, ensure that the ALC threshold is programmed correctly by setting the correct threshold.
How to fix absence of stereo modulation on Elenos ETG300?
If there is an absence of stereo modulation on your Elenos Transmitter, enable the stereo carrier from the user setup menu. Also, connect or replace the audio cable. Finally, insert stereo board and/or stereo encoder.
What to do if there is absence of RDS transmission on Elenos Transmitter?
If there is an absence of RDS transmission on your Elenos Transmitter, switch on RDS from the user setup menu. Reprogram the RDS board. Insert RDS board, if it is missing.
Guide to connecting and operating via telemetry using Hyper Terminal software.
Details main menu display, controls, logo customization, and timer functions.
Navigating functions menu for audio, RF, frequency, RDS, and setup.
Adjusting input signal level and understanding audio parameters like power.
Setting and adjusting the unit's output power level.
Programming and adjusting the operating frequency of the unit.
Configuring user settings and implementing password protection for menus.
Configuring RDS messaging, alternative frequencies, and radio text settings.
Instructions for programming the RDS encoder using PC software.
General| Power Output | 300 W |
|---|---|
| Frequency Range | 87.5 - 108 MHz |
| Modulation | FM |
| Efficiency | >70% |
| Cooling | Forced air |
| RF Output Connector | N-type |
| Input Voltage | 100-240 VAC |
| Input Frequency | 50/60 Hz |
| Power Supply | Internal |
To Next Page
