elero Compakt - Customer Service of the Manufacturer

5
General
EN
• Non-compliance with the safety stipulations, notices and directions provided
in these installation instructions
• Exceedingofthespeciedtechnicalspecications
1.6 Customer service of the manufacturer
The device may be repaired only by the manufacturer in the event of a fault. The
address for sending in the device to the customer service department can be
found on the inside of the back cover.
If you have not purchased the device directly from elero, please contact the
manufacturer of the machine or the supplier of the device.
Mechanically secure the machine before dismantling the device.
The device must not be separated from the machine by force.
The serial number must be at hand, if you request customer service. This can
be found in the top right-hand half of the type plate.