7
NR –
This key is only active in the Prog- Mode (Prog must be pressed before
and the LED Prog must shine) and has the following functions:
1. Begin of the program memory entry (after this, use
> - Button to step up)
2. Test of an existing program: Each pressing of
NR causes a continuous-switching into
the next program line.
3. Selection of any line in the table operation
> - The cursor button selects the preset windows sequentially.
On completion of a line, the next press of
> will select the next address line.
LEDs 1 – 3 indicate the selected Window.
E - This button will :
Set the end of program and reset the controller into operation mode.
This Button should be pressed only, when the last window is selected.
Confirm and save the entered values
End register setting at any point
R - Selector for entry of Register values. Only active when “Prog” selected
(LED
Prog shines)
T - Reset button : Resets all preset windows in program mode.
C - Clears selected Target window value
0… 9 - Numerical keys for data entry
To Next Page
Loading...
Need help?
General
