ELIS PLZE a. s., 425/15, , Czech Republic, phone.: +420 377 517 711, fax: +420 377 517 722 Es 90678K
instructions as described therein. Following the above mentioned
instructions will prevent the loss of warranty for reasons of incorrect installation and misapplication.
Installation of this flowmeter shall be performed only by a company trained for this purpose by ELIS
eiving the training, shall be fully responsible for the correct
caused by an incorrect installation, its wrong application or incompetent configuration or programming.
applicable standards. The accompanying documentation consists of Project design, installation and
service manual and Declaration of Conformity. The products have a warranty as stated in the
Confirmation of Purchase Order or in the Purchase Contract.
All product manuals are regularly updated and the current version is delivered together with the product
and also available on the Internet under www.elis.cz/en.
purchaser, s
General Terms and Conditions.
Deliveries of flowmeters shall be governed by the Czech Civil Code. The product is delivered pursuant
to the confirmed Purchase Order or P
differences in flowmeter parameters that were not confirmed in writing.
The following icons are used in the Project design, installation and service manual:
Warning: incorrect operation or erroneous flowmeter configuration may cause damage to
product or injury to persons.
Information about another flowmeter features or types of documents delivered together with
the product.
1.5 Product warranty
The flowmeter manufacturer provides product warranty in accordance with their valid commercial
conditions.
Additional information regarding warranty is included in Chapter 14 hereof.
1.6 Representations and certificates
Applicable to electromagnetic flowmeters of the FLONET FH30xx type series are representations and
certificates referred to in Chapter 17 below, namely:
• Representation on CE compliance
To Next Page
Loading...
Need help?
General
