www.elitescreens.co
eliteinfo
elitescreens.com
Rev. 1.3
SCREEN OPERATION
Note: Always pull the screen down or let it up in either a steep incline or a 90-degree vertical
angle. Do not allow the screen to touch the screen case when the screen goes up or comes down
to avoid damaging the screen material.
1. Pull the screen down with the lanyard or by the handle at either a sharp incline or in a 90-
degree angle. Do not attempt to pull the screen down by its material or touch the screen, as it will
cause damage and likely void the warranty. (Fig. 5)
Note: An internal auto-lock mechanism system will cause the screen to stop and lock on the
desired position at intervals.
2. If you want the screen to retract back, simply pull the screen down more than 5cm (2”) and
retract the screen back by guiding the retracting material in a swift but gentle motion. (Fig. 6) (It
is ideal to release at a 90-degree angle and do not let go until the screen is entirely inside the case)
Note: Improperly bringing the screen up/down will damage the screen material or rolling
system.
Fig. 6
Fi
. 5
To Next Page
Loading...
Need help?
General
