set
set
set
set
setset
set
set
set
set
set
set
PROGRAMMING MENU
To access the ‘Programming’ menu press for at least 5 secs the key. If specied, the ‘PA1’ access PASSWORD will
be requested (see ‘PASSWORD’ paragraph). At the access, the display will show the rst parameter (“diF”).
By pressing the and keys you can scroll all parameters in the Programming menu:
5 secs
Select the desired parameter using the and keys. Press to see the current value of the selected
parameter. Press and to change the value and then press to save it.
NOTE: It is strongly recommended that you switch the device off and on again each time the parameter conguration
is changed, in order to prevent malfunctioning of the conguration and/or ongoing timings.
PASSWORD
The password “PA1” allow access to the level 1 parameters (USEr) as the password “PA2” allow access to the level 2
parameters (Installer). The level 2 parameters group include also all the level 1 parameters.
Default setting has the password “PA1” disabled (value = 0) while the password “PA2” is enabled (value = 15).
To enabled the password “PA1” (value ≠ 0) and assign the required value, enter in the “Programming” menu, select the
parameter “PS1” with and keys, press the key, assign the required value and conrm it by pressing the
key again.
If the password “PA1” is already enable, at the access to the “Programming” menu, will be required to put in the
password “PA1” or “PA2” according to the parameters that you need to edit. To enter the password ‘PA1’ (or ‘PA2’):
5 secs
If the password is incorrect, the display will show the ‘PA1’ (or ‘PA2’) label and you will have to repeat the entry
procedure. It is possible to access to level 2 parameters also from level 1 parameters by selecting parameter ‘PA2’
(available at level 1) through and keys and then pressing the key.
To Next Page
Loading...
Need help?
General
