Elkay SWIRLFLO FLEXI-GUARD ezH2O EZWS-EDFPBM117K User Manual

2000000495 (Rev. A - 01/22)
EDFPBM117WS EDFPBM117WS-F
Page 1
Review these instructions before beginning installation. Be sure that installation
conforms to all plumbing, electrical and other applicable codes.
When installation is complete, ensure these instructions are left in the plastic bag
provided inside the installed unit for future reference.
Service to be performed by authorized service personnel only.
INSTALLER
NOTE: It is common practice to ground electrical hardware such as telephones, computers and other devices
to available water lines. This can, however, cause electrical feedback in the plumbing circuit, which
results in an “electrolysis” effect occurring in the fountain. This may result in water which has a
metallic taste to it or has a noticeable increase in the metallic content of the water.
When inspecting plumbing circuit, remember the line may be grounded some distance from the
installation, and may occur outside the building or area in which the unit is being installed.
This condition can be avoided (in most cases) by using recommended materials during installation.
Any drain ttings provided by the installer should be made of plastic which will electronically isolate
the fountain from the remainder of the building’s plumbing circuits.
LZWS-EDFPBM117KEZWS-EDFPBM117K
SWIRLFLO
®
Fountains with FLEXI-GUARD
®
and ezH2O
®
Bottle Filler
INSTALLATION & USE MANUAL

Elkay SWIRLFLO FLEXI-GUARD ezH2O EZWS-EDFPBM117K Specifications

General

ADA Compliant	Yes
Activation Method	Push Button
Installation Location	Outdoor
Material	Stainless Steel
Mounting Option	Wall Mount
Number of Stations	1
Rated For Outdoor Use	Yes
Category	Outdoor Fountain
Model	EZWS-EDFPBM117K
Brand	Elkay
Bubbler Material	Stainless Steel
Finish	Stainless Steel
Mounting Type	Wall Mount
Options	Filtered
Power	Non-Electric
Refrigeration Capacity	No Refrigeration
Filter Life	3, 000 gallons
Warranty	5 years

Summary

Installer Instructions

Safety and Installation Advisories

Includes cautions, warnings, and notes for proper installation and safety.

Rough-in Dimensions

Required Tools and Materials

Installation Procedures

Panel and Fountain Assembly

Steps for installing upper panel, fountain, and related components.

Bubbler Stream Adjustment

Guidance on checking and adjusting the bubbler stream height.

Bottle Filler Dispensing Test

Procedure to verify proper water dispensing from the bottle filler.

Filter Parts List

Control Board Programming

Software Verification and Access

Check software designation and access the programming button.

Filter Monitor Reset

Instructions to reset the visual filter monitor status.

IR Sensor Range Configuration

Adjust the infrared sensor range for optimal bottle detection.

Unit Type and Filter Capacity Setup

Configure unit type (refrigerated/non-refrigerated) and filter capacity.

Bottle Count Reset

Procedure to reset the bottle counter to zero.

Electrical Diagram

Parts and Connections

Water Supply Connections

Diagram and notes for connecting water supply lines.

Bottle Filler Parts Kits

List of replacement parts kits for the bottle filler.

Troubleshooting and Maintenance

Guidance on mineral deposits on orifice and stream regulator.

Quick Connect Fittings Operation

Instructions for attaching and detaching tubing from quick connect fittings.