Installing the new machine
This machine for the production of cold
drink, slush, and sherbets grants the
absolute homogeneity of the product
and the possibility to regulate its
density thanks to an innovative
electronic control. Before installing the
machine, verify that:
• First Class is not placed by an heat
source;
• The machine has not been
damaged during transportation. In
case of doubt, contact the supplier;
• The power supply system is
endowed with a grounding that
respects the rules of law;
• The power supply system capacity
is adequate to the maximum power
of the machine, as indicated on the
plate (pic. 4 pag.3).
In case of doubt, contact only qualified
staff.
In order to install the machine,
carefully read the following
instructions.
:
• "
• "
• "
a
• "
).
.
.
Warnings
This machine is only for the use it has
been manufactured for. Any other
usage is to be considered as improper
and dangerous.
Machine description (pic. 1 pag.3):
• Top light
• Transparent tank
• Auger ring nut
• Hooks for the tank removal
• Control electronic board
• Supply outlet
• Main switch
• Pressure switch light
• Drip tray
• Plate data
.
):
• "
• "
• "
• "
• "
• "
• "
• "
• "
• "
Installation
It is suggested that the machine is
installed only by qualified staff. A
wrong installation can cause damage
to people or things, for which things
the manufacturer declines any
responsibility. Once the machine is
unpacked, verify the integrity of the
machine. The packaging elements
(plastic bags, expanded polystyrene,
nails, etc.) must not be left at children
reach as they might be dangerous.
Remove the protection plastic stripes
also from the internal side of the grids.
We do not recommend to connect the
machine through adaptors, multiple
plugs and/or extensions. If necessary,
use only materials that conform to the
safety rules in force, as for the current
intensity up to what indicated on the
plate (pic. 4 pag.3).
Place the machine so as to avoid any
heat source to be close to the grids.
Verify that there is a free space of 25
cm at least around the machine (pic. 5
in appendix-25).
After connecting the machine to the
power supply and switching on the
main switch, verify that air comes out
from the side grids (pic. 6 in appendix-
25).
polystyrene
.
(
a
Lid stickers
All refrigerators are equipped with 2
stickers for each single lid. The
stickers must be applied as showed in
the pictures:
:
Right usage
Before switching on the machine, it is
necessary to clean it as indicated in
".
To Next Page
Loading...
Need help?
General
