Condenser cleaning
procedure
Remove the side panel of the 2 or 3
tanks machine, or the back panel of
the one tank machine by unscrewing
the screws on the bottom and clean
the radiator with a soft brush or (if
possible) with compressed air.
a
.
Outlet restriction
First Class has an accessory called
Restriction (pic. 28 in appendix-25), it
is a shaped piece that is applied on the
ending part of the transparent tank
outlet. It has the following advantages:
• The product, liquid (clod drink) or
semi-liquid (low density slush), is
canalized directly in the glass;
• The restriction is easy to pull out,
therefore, it is possible to easy
wash the ending part of the outlet
without having to dismantle the
whole transparent tank, with a
consequent decrease of the
machine cleaning times. In
summary, the only part which is
not refrigerated, where an
accumulation of the product is
more likely to happen, can be now
removed and washed.
This restriction has some gaskets
(O-ring) that must be wet with water
before inserting them on the outlet
terminal part. This is to make the
introduction easier and to avoid that O-
ring goes outside their proper
locations.
On the restriction there is the image of
an arrow and of a glass that, while
inserting it, must face the operator.
a
•
•
a
.
a
.
First Class Millennium
controls and signals
When you switch on the electronic
board, the display will show
SLUSH / MACHINE
V.30E
Where 0.15 indicates the tank review
number.
FC Millennium has a BASIC version
that only has the electronic board like
the one shown before, and an
ADVANCED version that has an
additional electronic kit in the machine
with additional features connected to
time.
Warning: The screen with the “/”
symbol indicates that the values are
shown alternatively.
After the screen shown above the
initial screen will be displayed:
.
a
san
.
.
:
StandBy
Press
WARNING: The electronic board will
keep the settings it had when the
machine was switched off.
.
When the tank is in stand-by mode,
the augers and the cooling system are
off. The augers and the gear motor
can be turned on by pressing the
button. The screen will show:
:
Motor on
Press < <> >
If you press the button, the
screen will display as follows:
::
To Next Page
Loading...
Need help?
General
