Elmo 16-CL Optical User Manual

o
4
Preparation for projection
Set up your projector and screen properly.
For steady projection, place the projector on a sturdy support
at right angle to the screen.
Making sure the master control power switch is at OFF, connect
the built-in power cord, which is stored in the top side receptacle
of the projector, to the AC electrical outlet.
Pull up the feed reel arm and take-up reel arm to maximum stop
position.
Turn the master control switch clockwise to a~ through
, , which will turn the projector on forward and switch on
the lamp. Then make adjustment for the projector and screen
positions for appropriate picture size. After the set-up is com-
pleted, turn the master
control switch counter-
clockwise to 0 F F posi-
tion.

Elmo 16-CL Optical Specifications

General

Brand	Elmo
Model	16-CL Optical
Category	Projector
Language	English