ELNA 3003 - Page 22

Pull the button holder
to the back and place
the button
Pass the needle thread
under the presser foot.
Models
3003 + 3005:
Push the button
holder firmly back to secure the button
Sew
slowly and stop the machine at the starting
point when a
Pull down
the buttonhole lever as far as it will go.
Place the fabric under the
presser foot. buttonhole
is completed
Turn
the balance
wheel towards
you, until
the needle descends
exactly at the
starting point
of the buttonhole.
Model 3007:
Lower the presser
foot.
Depress the foot control
until the machine stops by itself
*
When the buttonhole
is completed,
the
3BHW indicator
light
* The buttonhole
starts
with the barrack
The
left row is sewn
will
flash
backwards.
272
Cut threads at 10cm(14"). Pass the needle thread to the To repeat a buttonhole:
When buttonhole sewing is firished, raise the buttonhole lever
wrong
side of the
fabric by pulling
the bobbin thread
Knot the
After the buttonhole
is sewn, select
stitch I"
and return to
to its initial position.
threads. "RH" to be at the starting point of the buttonhole
Insert
a pin into
one of the bartacks
and cut
open carefully
with
the buttonhole
knife
ao