12
r Mode Key
Each time you press this key the mode will change in
the following order:
(1) Pattern selection mode
The green light on the top will turn on.
To select the pattern, press the key until the
pattern number of the desired stitch is indicated (see
the stitch chart below).
(2) Stitch width adjusting mode
The green light in the middle will turn on.
The stitch width of the selected pattern will be
indicated.
To alter the stitch width, press the key.
(3) Stitch length adjusting mode
The green light on the bottom will turn on.
The stitch length of the selected pattern will be
indicated.
To alter the stitch length, press the key.
t Direct Pattern Selection Keys
4 commonly used stitches can be selected by
pressing the corresponding key.
r
(1)
(2)
(3)
t
To Next Page
Loading...
Need help?
General
