ELNA eXperience 620 - Attaching and Removing Shank; Seam Allowance Lines; Controlling Sewing Speed

9
Attaching and Removing Shank
Turn OFF the power switch. Raise the presser bar. Turn
the thumbscrew q counterclockwise with the screwdriver
to remove the shank.
To attach, match the hole in the shank w with the hole in
the presser bar e. Put thumbscrew in hole and turn
clockwise to tighten.
Seam Allowance Lines
The lines on the needle plate, machine bed and bobbin
cover plate help you measure seam width. The number
indicates the distance between the center needle
position (3.5) and the seam allowance line.
q Center needle position
w Edge of fabric
e Guidelines
r 90º pivot angle guideline for 5/8˝
q
w
e
q
w
e
r
Controlling Sewing Speed
Sewing speed can be varied with the foot control. The
harder you press on the foot control, the faster the
machine runs.
The maximum sewing speed can be varied by sliding the
speed control lever. For a faster speed, slide it to the
right; for a slower speed, slide it to the left.