7
q
q
w
e
r
t
(+)
(–)
How To Drop the Feed Dog
The feed dog can be dropped out of position for special
sewing techniques: free motion embroidery, stippling,
button sewing, etc.
The feed dog must always be up for regular sewing.
Locate the feed dog lever on the back of the free arm.
Slide the lever either to the right (down) q or to the left
(up) w. To bring up the feed dog, hand turn the flywheel
after sliding lever to the left.
Circular Sewing Pivot Points
The free arm has holes q that are 1 cm apart from each
other. Use the holes to sew circles and scallops with the
circular sewing pivot pin.
wq
Using the Fine Adjustment Screw
Choice of fabrics and threads may affect the stitch
formation. The fine adjustment screw can be used to
either lengthen or shorten the stitch.
q Fine adjustment screw
w Standard mark
e Setting mark
To fine tune, use a screwdriver to move the setting mark.
• If stitches are too short r, correct by turning the
screw in the direction of “+”.
• If the stitches are too long t, correct by turning the
screw in the direction of “–”.
To Next Page
Loading...
