Rear VESA Mount
A four-hole, 400x400mm mounting pattern is provided on the rear of the IDS Display.
The VESA FDMI-compliant mounting is coded
- VESA MOUNT PER MIS-F, 400 x 400mm
- Elo recommends M6x15mm screws
Refer to www.elotouch.com for dimensional drawings.
Optional Mounting Methods
An optional low profile stand kit and wall-mount kit are available for the IDS ET3203L/ET4303L/ET5053L Displays. Detailed information
is available on the marketing specification drawing at www.elotouch.com.
Elo Low Profile Stand kit:
Elo Part Number: E722153
Drawing Numbers: MS602351/ MS602352/ MS602353 for IDS ET3203L/ET4303L/ET5053L
Consult the stand user guide for detailed installation information.
Elo Low Profile Wall Mount kit:
Elo Part Number: E721949
Drawing Numbers: MS602351/ MS602352/ MS602353 for IDS ET3203L/ET4303L/ET5053L
Consult the wall mount user guide for detailed installation information.
To Next Page
Loading...
