Manuale istruzioni LAVASCIUGA MOD. ZLA40 – ZLA40C – ZLA40CB
Fig 7
7.3. Mounting the brush
The brush is easily mounted raising the brush plate across the opposite third wheel near the
back of the machine, on the side SX of the brush plate, as shown in the pictures.
1. Switch off all motors, shutting down power to all the machine.
2. Using the raising lever on the brush plate, as shown in the Fig, turning until the third
wheel is not resting on the floor and the brush plate is raised off the floor.
3. Position the brush under the brush plate, central to the hub, and with two hands
pushing up with one decisive movement so it fastens and remains parallel to the
brush plate.
4. Make sure the brush is fixed and positioned on the hub. ( the pivots of the central hub
must sit in the seats as shown in fig 14.
5. Lower the brush plate ,again using the lever, in the opposite direction.
Switch power back on, and switch on brush rotation. Fig 8
05/07/11 Rev .0.0 Lavasciuga Mod.ZLA40 – ZLA40C – ZLA40CB
To Next Page
Loading...
