Elster EK260 - Interface Configuration Settings

Volume Conversion Device EK260
Elster GmbH 71
3.12 Interface list
The values displayed in this list depend on the set interface mode Md.S2 (see below):
a) All modes except "Modbus" (Md.S2 ≠ 13):
AD Designation / value Unit Access Address DC
Md.S2 Mode, Interface 2 - S 2:705 7
DF.S2 Data format, Interface 2 - S 2:707 7
Bd.S2 Baud rate, Interface 2 Bd S 2:708 7
TypS2 Type, Interface 2 - S 2:70A 7
Num.T Number of ringing tones before accepting call. - S 2:720 8
M.INI Initialise modem - S 2:728 2
PrLog Printer log - - 2:7E6 8
CSync Automatic setting of the clock by rem. data transfer - - 2:7D4 8
GSM.N GSM network - - 2:775 4
GSM.L Reception level - - 2:777 4
StM Modem status (GSM) - - 2:77C_1 4
P.Sta Response to PIN code - - 2:77A 20
PIN PIN code - S 2:772 11
Resp1 Response to Short Message 1 - - 2:742 20
Resp2 Response to Short Message 2 - - 2:74A 20
SEND Send short message (SMS) - S 2:734 2
Bd.S1 Baud rate, Interface 1 Bd S 1:709 7
CW1.S Call acceptance window 1, start - S 5:150 8
CW1.E Call acceptance window 1, end - S 5:158 8
CW2.S Call acceptance window 2, start - or:
M.CW1 Status message "Call acceptance window 1"
- S 6:150 8
CW2.E Call acceptance window 2, end - or:
M.onl Status message "FE230 online"
- S 6:158 8
b) Mode "Modbus" (Md.S2 = 13):
AD Designation / value Unit Access Address DC
Md.S2 Mode, Interface 2 - S 2:705 7
DF.S2 Data format, Interface 2 - S 2:707 7
Bd.S2 Baud rate, Interface 2 Bd S 2:708 7
TypS2 Type, Interface 2 - S 2:70A 7
Modb Modbus parameter - (C) 1:1C1 8
Bd.S1 Baud rate, Interface 1 Bd S 1:709 7
CW1.S Call Window 1, start - S 5:150 8
CW1.E Call Window 1, end - S 5:158 8
CW2.S Call Window 2, start - S 6:150 8
CW2.E Call Window 2, end - S 6:158 8
(Legends: see page 22)
Connection of a device to Interface 2 (permanently wired interface): → 5.5