ELTEX ESR-21 - Page 144

ESR series service routers.ESR-Series. User manual
144
Step Description Command Keys
esr(config-bridge)# ipv6 address
<IPV6-ADDR/LEN>
<IPV6-ADDR/LEN> – IP address
and prefix of a subnet, defined
as X:X:X:X::X/EE where each X
part takes values in
hexadecimal format [0..FFFF]
and EE takes values of [1..128].
For advanced IPv6 addressing
features see section IPv6
addressing configuration.
Several IPv4/IPv6 addresses
can be specified separated by
commas. Up to 8 IPv4/IPv6
addresses can be assigned to
the interface.
esr(config-bridge)# ip address
dhcp
For advanced DHCP client
operation features, see section
DHCP Client management.
9 Disable the Firewall features on the
interface or enable the interface in the
security zone (see Firewall
configuration).
esr(config-bridge)# ip firewall
disable
esr(config-bridge)# security-zone
<NAME>
<NAME> – security zone name,
set by the string of up to 31
characters.
10 Enable recording of the current
interface usage statistics (optional).
esr(config-bridge)# history
statistics
11 Specify the time interval during which
the statistics on the bridge load is
averaged (optional).
esr(config-bridge)# load-average
<TIME>
<TIME> – interval in seconds,
takes values of [5..150].
Default value: 5
12 Specify the network bridge MAC
address different from a system one
(optional).
esr(config-bridge)# mac-address
<ADDR>
<ADDR> – network bridge MAC
address, defined as
XX:XX:XX:XX:XX:XX where each
part takes the values of
[00..FF].