ELTEX ESR-21 - Page 248

ESR series service routers.ESR-Series. User manual
248
•
•
•
Step Description Command Keys
esr(config)# bridge <BR-NUM> <BR-NUM> – bridge number.
18 Set RIP routes metric value on the
interface (optional).
esr(config-if-gi)# ip rip metric
<VALUE>
<VALUE> – metric size, takes
values of [0..32767].
Default value: 5.
19 Set the routes advertising mode via RIP
(optional).
esr(config-if-gi)# ip rip mode
<MODE>
<MODE> – routes advertising
mode:
multicast – routes are
advertised in multicast
mode;
broadcast – routes are
advertised in broadcast
mode;
unicast – routes are
advertised to the
neighbors in unicast
mode;
Default value: multicast.
20 Specify a neighbor’s IP address for
establishment of a relation in routes
advertising unicast mode (optional).
esr(config-if-gi)# ip rip neighbor
<ADDR>
<ADDR> – IP address, defined
as AAA.BBB.CCC.DDD where
each part takes values of
[0..255].
21 Enable subnet summarization
(optional).
esr(config-if-gi)# ip rip summary-
address <ADDR/LEN>
<ADDR/LEN> – IP address and
subnet mask, defined as
AAA.BBB.CCC.DDD/EE where
each part AAA-DDD takes
values of [0..255] and EE takes
values of [1..32].