ELTEX NTU-2V - The Wi-Fi Menu. Wi-Fi Network Setup; The Basic Submenu. General

____________________________________________________________________________________
____________________________________________________________________________________
NTU-2V, NTU-RG Optical Network Terminals 39
4.5 The Wi-Fi Menu. Wi-Fi Network Setup
4.5.1 The Basic Submenu. General
This menu is intended for general setup of the LAN wireless interface and allows user to specify up to
three wireless access points.
— Enable Wireless – enables Wi-Fi on device;
— Enable Wireless Hotspot2.0 – enables Hotspot2.0 support on device;
— Hide Access Point – sets access point into the hidden mode (router will not broadcast SSID of the
wireless network in this mode);
— Clients Isolation – when the flag is set, wireless clients can not communicate to each other;
— Disable WMM Advertise – disables WMM (Wi-Fi Multimedia – a QoS for wireless networks);
— Enable Wireless Multicast Forwarding (WMF) – enables WMF;
— SSID (Service Set Identifier) – assigns a name to the wireless network (case-sensitive keyboard input);
The default name (SSID) of the wireless network is ELTEX-aaaa,
where аааа are the last 4 digits of WAN MAC. WAN MAC is labelled on the device housing.
— BSSID – МАС address of the access point;
— Country – specifies location (country);
— Country RegRev – specifies region ID (0-34 for Russia);
— Max Clients – the maximum possible number of simultaneously supported wireless connections.
Click the Apply/Save button to accept the changes.