ELTEX NTU-52V - Page 28

 NTU-52V/VC. User manual (user)
28
•
•
•
•
Added filters are displayed in the'Current Filter Table' located below. The entries in this table are used to
restrict certain types of data packets pass through the gateway. To delete a specific filter, select the position
and click the 'Delete selected' button, to delete all filters click 'Delete All'.
5.3.3.2 The 'MAC Filtering' submenu. Filtering Settings for MAC Addresses
MAC filtering allows traffic to be forwarded or blocked depending on source and destination MAC addresses.
To change the mode click the 'Apply Changes' button.
Services → Firewall → MAC Filtering
Default Action– default settings:
Deny – when checked, traffic pass is prohibited by default;
Allow –when checked, traffic pass is allowed by default;
MAC Address–MAC address for which limitation/access should be imposed.
Added filters are displayed in the'Current Filter Table' located below. The'Rule'field displays the type of
created rule ('Allow' - allowingor'Deny' - forbidding). To remove selected items in the list, click'Delete
Selected';click'Delete All'to remove the whole list.