ELTEX NTU-52V - The Firmware Upgrade Submenu. Software Update; The Remote Access Submenu. Remote Access Rules Configuration

 NTU-52V/VC. User manual (user)
44
•
•
•
•
5.6.5 The 'Firmware upgrade' submenu. Software Update
To update firmware, it is necessary to select firmware file by using the'Select file'button and
click'Upgrade'.To reset the value, click the'Reset'button.
Admin → Firmware upgrade
5.6.6 The 'Remote Access' submenu. Remote access rules configuration
In this section you can configure remote access rules via HTTP/Telnet/ICMP protocols.
Admin → Remote Access
Enable – enabling the rule to add;
Service – selection of the protocol used;
Interface – interface to which the rule applies;
IP Address – source IP adress;
Do not switch off or reboot the device during the update. The process may take several minutes. The
device will be automatically rebooted when the update is completed.
