NTU-52V/VC. User manual (user)
1.
2.
3.
4.
To view the routes that the device often accesses, click the 'Show Routes' button, then the 'IP Route Table' will
be displayed.
Advance → Routing→ Show Routes
To update the information in the table, click the 'Refresh' button, to close the table, click 'Close'.
5.4.4 The 'Bridging grouping' submenu. Interface grouping
In this section you can group the interfaces. By default all interfaces are in the same group. To place an
interface to a new group, you should:
Select a new group from the list below;
Select interfaces from the 'Available Interface' list;
Click the arrow ← to transfer the interfaces into the group;
Apply the actions by clicking the'Apply Changes'button
Advance → Bridge grouping
To Next Page
Loading...
