– CAPACITANCE NOT MEASURED–means that during the line resistance measurement one of the values was
lower than the minimum allowed value for line capacitance measurement (1800Ω). As a rule, this error may
be caused by a phone offhook or a wire or ground short circuit;
– EXTERNAL VOLTAGE FAILURE–external voltage measured in line wires falls outside of allowable limits (-5V -
+5V);
– TEST ERROR–test is interrupted by a processor command.
Click the Hide test result button to remove test result information.
When you click the Hide all button the results of tests of all types will be removed.
Performed Call Statistics
The Get stat button located against each port allows to get the statistics on performed calls for the
specific port. Statistics form is formed by clicking on this button. To see the statistics, hover the mouse
cursor over the 'results' link located against the respective port, or open the test results window by clicking
the link:
– State–current port status:
• offhook–phone is offhook;
• onhook–phone is onhook;
• FXO offhook – FXO port is busy;
• FXO onhook – FXO port is availiable;
• dial–dialling number;
• ringback–send 'ringback' tone;
• ringing–send 'ringing' tone;
• talking–call in progress;
• conference–3-way conference;
• busy–sending 'busy' tone;
• hold–port is on hold;
• testing–port is in testing mode.
– Call count–number of outgoing calls from the gateway startup;
– Call phone–last dialled number;
– Peak jitter–maximum jitter;
– Lost packets–quantity of lost packets;
– Transmitted packets–quantity of transferred voice packets;
– Transmitted octets–quantity of bytes in transferred voice packets;
To Next Page
Loading...
