elv FHT8-Set - Page 64

64
operating mode.
b) Selecting the temperature unit (“°C°F”)
You may set whether the temperature is to be displayed in
degreesCelsius(°C)ordegreesFahrenheit(°F).
•Pressthe“PROG”keyuntil“Sond”isdisplayed(forspe-
cial function).
•Use the selection wheel to select the special function
“°C°F”.
•Toconrmyourselection,brieypressthe“PROG”key.
•Use the selection wheel to switch between “°C” and
“°F”.
•To conrm your selection, briey press the “PROG”
key. The heating control returns to the normal operating
mode.
c) Setting of date and time (“dAt”)
•Pressthe“PROG”keyuntil“Sond”isdisplayed.
• Use the selection wheel to select the special function
“dAt”.
•Toconrmyourselection,brieypressthe“PROG”key.
d) Setting the safety code (“CodE”)
To protect the heating control against interference from oth-
er radio systems the device uses a safety code consisting
of two parts. Each part of the code comprises 100 setting
options. This means that there are 10,000 different safety
codes available.
To ensure communication between the “FHT8R” heating
control and the “FHT8V” valve operating mechanism/s
the same safety code has to be set for all devices in a
room.