elv FHT8-Set - Page 66

66
•Thefollowingdataaredisplayed:
MO
DI MI
DO FR
SA
SO
0
6
12
18
24
Now you have to synchronise the (first) valve operating
mechanism (“001” on the display) to the new safety code.
Proceedasfollowstosynchronisethedata:
•Removethebatterycompartmentcoverofthe(rst)valve
operating mechanism by sliding it down.
•Pressthekeyofthevalveoperatingmechanismforabout
3 seconds until you hear an acoustic signal (3 separate
tones). The valve operating mechanism is now ready to
receive,“AC”isdisplayed.
•Pressthe“PROG”keyonthe“FHT8R”heatingcontrolto
start transmission of the safety code to the valve operat-
ing mechanism.
•The valve operating mechanism acknowledges correct
reception of the code with an acoustic signal (sequence
of tones).
•Replacethecoverofthebatterycompartment.
• The valve operating mechanism acknowledges the rst
reception of a normal radio signal with an acoustic sig-
nal.
Repeat these steps for all other valve operating mecha-
nisms in the room (“002”, “003”, etc. on the display).