EMC CX4 Series - Page 41

EMC Rails and Enclosures (CX4 Series Storage Systems) Field Installation Guide
41
Installing a 4U storage processor enclosure (SPE) in a cabinet
Removing the filler panels
In most cases, the space into which you will install your enclosure is
covered by a filler panel, which is attached to latch brackets.
Remove any filler panel, then use a flat-blade screwdriver or similar
tool to pry off the latch brackets. Figure 33 shows how to remove a
common filler panel and latch bracket.
4U bezel (front rack panel) with keys EMI shielding
Adapter flanges and latch brackets Attach front bezel to cabinet
Flathead 8x32 screws Attach SPE to adjustable rails
Table 7 Enclosure mounting kit materials (continued)
Component Use
CL4065