Installing railsInstalling rails
InstallinInstalling the g the DPE railsDPE rails
The DPE rails should be installed first, at the bottom of the cabinet. The left adjustable rail has aThe DPE rails should be installed first, at the bottom of the cabinet. The left adjustable rail has a
connector protrudconnector protruding from the front which goes through ing from the front which goes through a hole in tha hole in the front channel of the cabinete front channel of the cabinet
and will connect to light the and will connect to light the bezel.bezel.
IMPORTANTIMPORTANT
All rails must be aligned level front to All rails must be aligned level front to back and with the companion rail, left to back and with the companion rail, left to right.right.
1.1. Insert the adjusInsert the adjustable 3U table 3U rail slide anrail slide and seat bd seat both alignment oth alignment pins into the pins into the rear crear channel of hannel of youryour
cabinet.cabinet.
2.2. ExtenExtend the raid the rail and aligl and align the fron the front of the rnt of the rails as sails as shown inhown in Fi
Figugurere 44. Ensure the . Ensure the connectorconnector
extends through a hole in extends through a hole in the front channel.the front channel.
3.3. InseInsert two retert two retentiontion screwn screws in the two hols in the two holes indices indicated in the frated in the front.ont.
4.4. Insert tInsert two retwo retentioention scren screws in the bws in the back of eack of each raach rail.il.
To Next Page
Loading...
Need help?
General
