EMC VNX5300 - Page 61

Disk-array enclosure expansion
61
EMC® VNX5300™ Hardware Information Guide
Figure 57 shows an example of the rear view of a 3U, 15 (3.5-inch) DAE.
Figure 57 3U, 15 (3.5-inch) DAE with two LCCs and two power supply/cooling modules (rear view)
As shown in Figure 57, an enclosure ID
17
indicator is located on each LCC. Each LCC
also includes a bus (back-end port) identification indicator. The SP initializes the bus
ID when the operating system is loaded.
Note: An LCC may be in either the A slot, as shown, or the B slot above it, depending on the
DAE placement within a system. For example, the front DAE in some systems is in slot A; the
rear enclosure LCC is inverted, and in slot B.
1 LCC B AC power supply power in (recessed plug) 7 LCC B SAS connector (output)
a
a. The SAS connector (output) is labeled with a double diamond symbol.
2 LCC B power supply fan fault LED (on, amber) 8 LCC B SAS connector (input)
b
b. The SAS connector (input) is labeled with a double circle (or dot) symbol.
3 LLC B power supply LED (on, green) 9 LCC B bus ID
4 LCC B power supply fault LED (on, amber) 10 LCC B bus LED (fault, amber)
5 LCC B management (RJ-12) connector to SPS
(not used)
11 LCC B bus LED (on, green)
6 LCC B SAS connector link LED 12 DAE enclosure ID
c
c. The DAE enclosure ID is sometimes referred to as the enclosure address (EA).
A
B
#
X4
6Gb SAS
#
X4
6Gb SAS
LCC B
LCC A
VNX-000100
2
4
1
567 9
10 11 12
8
3
17. The enclosure ID is sometimes referred to as the enclosure address (EA).