Emcee 1152 - Safety Warnings and Markings; Grounding and Intrinsic Safety Warnings; Battery Replacement Safety Requirements

DIGITAL CONDUCTIVITY METER
The information contained in the accompanying document is proprietary and confidential, and may not be
copied in any manner whatsoever without prior written consent of Emcee Electronics, Inc. The document
and the material therein may not be used for any purpose other than that intended by Emcee Electronics,
Inc.
COPYRIGHT 1984 EMCEE ELECTRONICS, INC.
REVISION DATE: JANUARY 10, 2019
Page 13 of 20
11.0 WARNINGS and MARKINGS
11.1 This device must be grounded before and
after introduction into the tank and remain
grounded until after complete withdrawal from
the tank.
ATTENTION: CE DISPOSITIF DOIT ÊTRE MIS À LA
TERRE AVANT DE L’INTRODUIRE DANS LE ÉSERVOIR.
MAINTENIR LA CONNEXION À LA TERRE AUSSI
LONGTEMPS QUE LE DISPOSITIF N’AURA PAS ÉTÉ
RETIRÉ DU RÉSERVOIR
11.2 Substitution of components may impair
intrinsic safety.
AVERTISSEMENT: LA SUBSTITUTION DE COMPOSANTS
PEUT COMPROMETTRE LA SÉCURTIÉ INTRINSÈQUE
11.3 Battery replacement must be (3)
Energizer No. A544 Alkaline, 6v each any
other battery replacement will invalidate the
Intrinsically Safe Rating.
Le remplacement de la batterie doit être (3)
Energizer no. A544 alCaline, 6V chaque autre
remplacement de la batterie invalidera la
cote de sécurité intrinsèque.