DIGITAL CONDUCTIVITY METER
The information contained in the accompanying document is proprietary and confidential, and
may not be copied in any manner whatsoever without prior written consent of Emcee
Electronics, Inc. The document and the material therein may not be used for any purpose other
than that intended by Emcee Electronics, Inc.
COPYRIGHT 2005 EMCEE ELECTRONICS, INC.
REVISION DATE: October 23, 2014
Page 2 of 11
Specifications of the Emcee Model 1153 Digital Conductivity Meter
Continuous Standard Electrical Conductivity Ranges from
0 to 2,000 picosiemens per meter (pS/m)
0 to 20,000 picosiemens per meter (pS/m)
0 to 2,000 picosiemens per centimeter (pS/cm)
0 to 20,000 picosiemens per centimeter (pS/cm)
0 to 100,000 picosiemens per centimeter (pS/cm)
One Pressure Sensitive Switch Operation (Green/White MC Logo)
Red LED Illuminates During Automatic Test Cycle (3 seconds)
Data Stored (Non Volatile) Until Next Test Cycle is Performed
Alphanumeric Liquid Crystal Display (LCD)
Conductivity Measured and Displayed in Whole Numbers
(pS/m or pS/cm)
Optional Embedded Temperature Sensor Available
Text Presentation of Operational Status of Meter is Displayed
Automatic Over Range (OVER) and Low Battery (LOW BAT)
Indications
Powered by Three-Standard (3-volt) Lithium Cylindrical Cells (Generic
Code Panasonic CR 2016)
Fuel and Water Resistant
Approved as being Intrinsically Safe
Listed in American Society of Test and Materials (ASTM)
Standard Test Method D 2624
To Next Page
Loading...
