ENGLISH MANUAL (model 4)
13
5 Practical information
5.1 Charging
Before using the EMDR Kit for the first time, we advise to charge the parts for 12 hours.
Connect the adapter supplied to the back of the Light Tube and place the Pulsators in the docking-
stations positioned on the base of the Light tube. The LED indicators will start blinking red when
charging and will turn green when fully charged.
When the battery of the Light Tube is empty, but you want to use it anyway, connect the Light tube
to the adapter. The Light tube is then ready for use.
Please note: When the Pulsator batteries are empty, they must be re-charged before further use. So
always ensure that these are charged before use.
You can charge the Headphone with the included mini-USB charger.
Increase the life of the batteries by not charging unnecessarily long.
Light Tube and Pulsators LED color indicators
The LED’s on the Pulsators and Light tube signal their status with the following colors:
Blue, flashing : Ready to connect
Blue, stable : Connected
Green, stable : Battery Charging complete
Red, flashing : Battery Charging
Red, stable : Battery running empty
Blue, flasing with Green or Red in between: Pulsators are charged/charging and ready to connect.
Headphone LED color indicator
Blue & Red, flashing: Ready to connect
Blue, Flashing: Connected, Ready to use.
Red: Battery Charging
5.2 Cleaning
Regularly clear any dust on the contact points of the pulsators and in the dockingstations to prevent
charging problems. You can do this by using a tissue with some alcohol.
To Next Page
Loading...