Emec VMS MF - Password Setup; Protecting Setup Menu Access

29
SET [12]
password
password
0000
Key
E
Password Setup.
“Setup” menu is password protected. Default value to enter into “setup” menu
is “0000” (only numeric units). To change this password proceed as follows:
- Use “UP” key to change first digit.
- Press “RIGHT” key to move cursor over next digit.
- Press “E” key to save data and “ESC” to exit to
main menu. Otherwise press “ESC” to discard data and exit
to main menu.
Note: For lost password, please, follow the “Load default”
procedure.