EasyManuals Logo

Emerson 7400 Series User Manual

Emerson 7400 Series
67 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
21
Series 7400 Single Phase 1+N UPS
3.1 Introduction
WARNING
Do not apply electrical power to the UPS equipment before the arrival of the
commissioning engineer
WARNING
The UPS equipment should be installed by a qualified engineer in accordance
with the information contained in this chapter and the drawing package shipped
inside the UPS cabinet.
WARNING
BATTERY HAZARDS
Ø Special care should be taken when working with the batteries associated
with this equipment. When connected together, the battery terminal voltage
will exceed 400Vdc and is potentially lethal.
Ø Eye protection should be worn to prevent injury from accidental electrical
arcs.
Ø If a ‘sealed’ battery leaks electrolyte, or is otherwise physically damaged, it
should be placed in a container resistant to sulphuric acid and disposed of in
accordance with local regulations.
Ø If electrolyte comes into contact with the skin, the affected area should be
washed immediately.
This chapter contains information regarding the positioning and
cabling of the one-plus-one UPS equipment and batteries.
Because every site has its peculiarities, it is not the aim of this
chapter to provide step-by-step installation instructions, but to act
as guide as to the general procedures and practices that should be
observed by the installing engineer.
Chapter 3Chapter 3
Installation Procedure

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Emerson 7400 Series and is the answer not in the manual?

Emerson 7400 Series Specifications

General IconGeneral
BrandEmerson
Model7400 Series
CategoryUPS
LanguageEnglish

Related product manuals