Manual setup
In this option, you have to define the settings in several tabs as shown below.
Wireless tab
Click Join Device to Network to enter network identifiers and join keys that will enable the
monitor to join a wireless network.
Click Configure Update Rate to set how often the device acquires and reports new
measurements (update rate) and to specify the number of times the monitor skips data
acquisitions between updates to the gateway.
Click Apply Default Burst Configuration to reset the burst configuration to default values.
Note
The burst messages are not individually controllable via the DD.
Configuration User Guide
August 2020 MHM-97927-PBF
24 MHM-97927-PBF, Rev 1
To Next Page
Loading...
Need help?
General
