May 2012
Service Instructions
137465E Rev. F
3
Section 1: Introduction
Introduction
1�4 Bettis reference materials
1.4.1 CBBXXX Assembly Drawing use part number 152230.
1.4.2 CBBXXX-M3HW Assembly Drawing use part number 152608.
1�5 Service support items
1.5.1 Bettis Service Kit.
1.5.2 Commercial leak testing solution.
1.5.3 Non-hardening thread sealant.
1�6 Lubrication requirements
1.6.1 The actuator should be re-lubricated at the beginning of each service interval
using the following recommended lubricants.
NOTE:
Lubricants other than those listed in steps 1.6.2 should not be used without prior written ap-
proval of Bettis Product Engineering. The lubricant item number on some assembly drawings is
item (5) while the Bettis service kits lubricant item number is item number (500).
1.6.2 All temperature services (-50°F to +350°F)/(-45.5°C to 176.6°C) use Bettis ESL-5
lubricant. ESL-5 lubricant is contained in the Bettis Module Service Kit in tubes and
the tubes are marked ESL-4,5 & 10 lubricant.
1�7 General tool information
1.7.1 All threads on CBB series actuators are Inch Unied and NPT.
1.7.2 All tools/Hexagons are American Standard inch. Two adjustable wrenches, Allen
wrench set, small standard screwdriver with sharp edges rounded off, medium size
standard screwdriver, diagonal cutting pliers, external snap ring pliers, at le, drive
ratchet / deepwell socket set and torque wrench (up to 2,000 inch pounds / 226 N-m).
To Next Page
Loading...
