What to do if the actuator of my Emerson Bettis SCE300 Controller does not work from remote controls?
If the actuator of your Emerson Controller isn't working from remote controls, verify that the wiring to terminals 32, 35, and 36 is correct and that there are no short circuits between wires. Also, ensure the electrical load doesn't exceed 4 W. If an external voltage is used, it should be in the 24-120 V AC/DC range.
How to troubleshoot Emerson Bettis SCE300 Controller electronics not switching on?
If the electronics of your Emerson Controller do not switch on when powered, check that the value of the main voltage on terminals L1 and L2 (and in the same case L3) is correct. Remove the cover assembly. Check the continuity of the wires between terminals L1, L2, L3 and the connector of the power card. If there is no continuity on the L1-L2-L3 cables, replace the terminal board. If continuity on the L1, L2, L3 cables checks out OK, replace the entire drive and control unit.
Why is the motor of my Emerson Bettis SCE300 very hot and not starting?
If the motor of your Emerson Controller is very hot and doesn't start, first wait for it to cool down before trying to use the actuator again. Also, ensure that the number of operations per hour and their duration are suitable for the actuator service, referring to the nameplate. Check that the valve operating torque is within the unit’s designed operating torque. Always check the causes of abnormal operation.
How to fix 24 V DC output voltage not available at the terminals of Emerson Controller?
If the 24 V DC output voltage is not available at the terminals of your Emerson Controller, first switch off the main power supply and disconnect all wires from terminals 33 and 34. Then, switch the main power supply back on and check if the voltage on terminals 33 and 34 is between 22 and 26 V DC. If the voltage is correct, check the external wiring and the electrical load, ensuring it doesn't exceed 4 W. If the voltage is still incorrect, replace the entire drive and control unit.
What to do if the motor runs but the actuator does not move the valve on my Emerson Controller?
If the motor of your Emerson Controller runs but the actuator doesn't move the valve, verify that the drive insert correctly fits in the actuator base and has enough engagement with the valve stem. Also, check that the key correctly fits in bore/keyway applications. Check that the valve works in manual operation. If not, it is necessary to check the manual control area as follows: Loosen the handwheel security dowel, Remove the handwheel, Check the integrity of the internal parts, When proceeding with assembly, follow the reverse order of the disassembly, Make sure there are no foreign bodies present and take care not to damage the O-ring seals or gaskets.
General| Category | Controller |
|---|---|
| Type | Electric Actuator Controller |
| Brand | Emerson |
| Model | SCE300 |
| Communication Protocol | Modbus RTU |
| Enclosure Rating | NEMA 4X |
| Operating Temperature | -40°C to +70°C |
| Housing Material | Aluminum |
To Next Page